![]() ![]() Recently I've several channels showing input, sending output to mixbus and FX, but refuses to send to LR mains. Everything appears normal viewing the main bus except nothing on the meters. Before when I had this a reboot usually fixed it, but last week I had to resave the routing settings. Tonight I had 3 mics quit in the middle of practice - monitors still fine, just no mains, other channels still working fine, and I didn't have my hands anywhere near the desk when it happened.įiddled around with it for a while. #Behinger x32 output factory settings full(Check out for Full Manual) X32 RACK DIGITAL MIXER 40-Input. The X32 PRODUCER is a robust-yet-streamlined mixer that features all of the core functionality and processing of BEHRINGERs flagship X32 console in a smaller form factor. Reset to factory and restored everything. Output signals are configured on the Routing/Aux Out page of the MAIN DISPLAY. By plugging in a USB thumb drive, I could record a stereo mix (or whatever I wanted to route to the thumb drive) the. Enabled / Disabled every processing / effect I know. 6 AUX Out: 6.3 mm Jack (optional 2 via RCA) AES / EBU stereo digital output 2 Headphone outputs: 6.3 mm jack Stereo monitor / control room output. Reset to factory and manually set just one channel. The Input section is home for 16 high-resolution 100 mm motorized faders, providing control over channels 1-16, 17-32, Aux inputs / USB playback /. Extensive Google-Fu netted me a few reports of similar things, usually with a whole block of inputs, and seeming to revolve around routing setup, but firmware seemed to fix those problems. and each TRS aux output its respective insert. Routing EQ settings FX settings, sends ect and what does not get backed up. I am not even sure this will fix it, but what steps should I take to make sure everything is backed up. My only access to saving anything is VIA PC connected directly into the Ethernet cable. I can move those inputs for now, but it's irritating me, and I don't need anything else to fail. So my screen is dead and im wondering if a factory reset my cause it to reboot. Im often asked what input options we have with the Behringer X32. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |